Fixpad 7.2 cm for First Alert smoke detector series 700

Are you looking for a quick and easy way to mount First Alert smoke detectors?

Buy the Fixpad with a diameter of 7.2 cm for easy and clean installation, especially for First Alert smoke detectors of the 700 series, at a reasonable price here. This FixPad consists of an adhesive foam film coated on both sides, especially for the installation of smoke detectors, carbon monoxide detectors, etc.

Only at room temperature is the FixPad glued with one side to the (clean, possibly cleaned) mounting plate of the smoke alarm.

Then peel off the film from the second side and stick the smoke detector mounting plate onto the ceiling in the previously cleaned mounting area. After sticking the mounting plate on, press it firmly and hold it down for at least a minute. This is the only way to create a firm connection with the ceiling. Then insert the smoke detector into the mounting plate.

Attention: The flexible structure of the FixPad can compensate for slight unevenness in the surface. However, the surface should have the following properties: even, free of dirt, dust, oil, grease and
load-bearing. For example, when attaching the adhesive pad - Fixpad to a ceiling with loose paint, it can be difficult. If this is not guaranteed, a permanent and secure connection cannot be achieved. If the surface is not suitable, fastening with screws is recommended.


Advantages:
- No drilling, no noise
- Saves time
- Clean, residue-free attachment
- Extremely cost-effective


Technical data:
Material: Coated polyethylene foam
Lower processing temperature: 10 C
Maximum usage temperature: 40 C